Page 2
INSTALLATION INSTRUCTIONS
CAUTION: Before installing, make certain the A.C. power is off.
1. MOUNTING THE ETS-STEP
Remove the driver channel cover. Mount the
ETS-STEP
in the ballast/driver channel at least ½
″
away
from the A.C. ballast/driver(s).
2. WIRING
Refer to the wiring diagrams on the back page for the appropriate wiring of ballast/driver. Install in ac-
cordance with the National Electrical Code and local regulations. For additional wiring diagrams consult
Customer Service.
3. INSTALLING THE AC INDICATOR
Recessed Troffer Fixture
– Select a convenient location with proper clearance in the ballast/driver
channel cover and drill or punch a
7
/
8
″
hole (
1
/
2
″
knockout). Insert the
7
/
8
″
bushing into the hole. Push the
plastic tube through the bushing. Disconnect the leads from the
A.C. Indicator
housing and route the
leads down the plastic tube. Reconnect the leads to the housing, observing the proper polarity (Yellow
lead to red marked or positive (+) red tab). Push the entire assembly back into the tube until the lens
collar rests against the plastic tube. The plastic tube should be adjusted so that the
A.C. Indicator
is
within ¼
″
of the fixture lens. The
A.C. Indicator
must be visible after installation.
Refer to Illustration 1.
Strip Fixture
– Select a convenient location on the side of the fixture so the
A.C. Indicator
can be
seen after installation. Allow for proper clearance inside the fixture and drill or punch a ½
″
hole. Discon-
nect the leads from the
A.C. Indicator
housing. Push the
A.C. Indicator
housing into the ½
″
hole until it
is firmly locked in place. Reconnect the leads, observing the proper polarity (Yellow lead to red marked
or positive (+) red tab). Refer to
Illustration 2.
4.
WIRING THE A.C. INPUT
Refer to wiring diagrams on Page 4 for the proper wiring configuration of the
ETS-STEP
. For wiring
diagrams not shown, consult Customer Service.
7/8" BUSHING
FIXTURE
BALLAST CHANNEL COVER
PLASTIC TUBE
CHARGE INDICATOR
LIGHT
FIXTURE LENS
Illustration 1 Recessed Troffer Fixture
FIXTURE
AC INDICATOR
+ RED
LEAD
WHITE/RED
LEAD
+ RED
Illustration 2
Strip Fixture
ETS-STEP
OBSERVE PROPER POLARITY
ETS-STEP
LENS
YELLOW/WHITE
LEAD
YELLOW
LEAD
