IMPORTANT SAFEGUARDS
When using electrical equipment, basic safety precautions should always be followed, including the following:
READ AND FOLLOW ALL SAFETY INSTRUCTIONS
1.
CAUTION
– This fixture provides more than one power supply output source. To reduce the risk of electrical
shock, disconnect both normal and emergency sources by turning off the A.C. branch circuit.
2.
CAUTION
– This is a sealed unit. Replace the entire unit when necessary.
3.
DO NOT USE OUTDOORS.
The
ETS-STEP
is for use with grounded, UL Listed, indoor fixtures. Not for use in
heated air outlets or hazardous locations.
4. The
ETS-STEP
requires an unswitched A.C. power source of either 120 or 277 volts. Properly cap the
unused A.C. lead.
5. Do not mount near gas or electric heaters.
6. The
ETS-STEP
should be mounted in locations and at heights where it will not readily be subjected to tamper-
ing by unauthorized personnel.
7. The
ETS-STEP
is compatible with all A.C. magnetic and electronic ballasts and drivers.
8. The
ETS-STEP
is for use in step-dimming applications and not designed for use with 0-10 volt dimming
controls. May be suitable for use in some 3-wire dimming applications. Contact Customer Service for more
information.
9. The use of accessory equipment not recommended by the manufacturer may cause an unsafe condition.
10. Do not use this equipment for other than intended use.
11. Install in accordance with the National Electrical Code and local regulations.
12. Installation and servicing should be performed by qualified personnel.
13. Lighting fixture manufacturers, electricians, and end-users need to ensure product system compatibility before
final installation.
SAVE THESE INSTRUCTIONS
ETS-STEP
EMERGENCY LIGHTING
CONTROL DEVICE
FOR STEP DIMMING
SERIES ALCR for 3A CIRCUIT
INSTRUCTION MANUAL
P.O. BOX 11846 TUCSON, AZ 85734
(520) 294-3292 • FAX (520) 741-2837
www.iotaengineering.com
