— APIS FUZZ (2021-06-30)
4. MOUNT THE FOOTSWITCH
Insert the footswitch and fasten it lightly. Make sure the bottom nut is as close to the
footswitch body as possible, otherwise the PCB will not sit low enough in the enclosure.
5. WIRE UP THE DC JACK
Measure two wires of about 3.5 cm length and strip off about five millimetres of
insulation at each end.
Solder them to the DC jack and mount the DC jack inside the enclosure, threading the
two wires through the nut. Check the PCB for the orientation of the +9V and GND pads.
Tighten the nut of the DC jack and solder the two wires to the PCB. The longer lug of the
DC jack must connect to the +9V pad.
•Top Nut
•Flat Shim Washer
(Enclosure)
•Split Lock Washer
•Bottom Nut
Summary of Contents for APIS FUZZ
Page 8: ...APIS FUZZ 2021 06 30...
