iOptron C704A0, Instruction Manual

Page: 28 / 58

28

“
Set Position Limit
” will tell the mount when to stop tracking or to do a meridian flip. The limit can
be set at from 0° to 10° pass meridian.

“
Set Behavior
” will tell the mount if a meridian flip will be performed.
5.4.8. Set Altitude Limit
This function allows the mount to keep tracking an object even if it is below the horizon but can still
be seen, for example from an elevated observation site, such as a hill. The range can be set from -89° to
+89°. The default limit is 00°.
Be careful when setting this limit. It may cause mount goto problems.
5.4.9. Enable CW Up Position
This setting will allow the CW moving to an up position. The upward angle limit is same as the
meridian flipping setting, or 14 degree at maximum. When this set is enabled, the mount will goto pass the
meridian if an object is close to the meridian, within the angle limit. There will be no meridian flip when pass
the meridian.
5.4.10. HC Heating Switch
Turn on/off the controller LCD back heater. When
“
Heating ON
” is selected, the heater will
automatically be turned on when the ambient temperature reaches 0°C (32°F) and shut off at 10°C.
5.4.11. Set RA Guiding
The function is for CEM70EC only. You can turn off R.A. guiding by selecting
“
Filter R.A. Guiding
”
to allow the high precision encoder to correct the tracking error, or turn the R.A. guiding on by selecting
“
Allow RA Guiding
” to allow the mount to receive guiding corrections from the guiding software. The power
on default s
etting is “
Allow RA Guiding
”.
5.4.12. Wi-Fi Options
This function will display WI-FI module functions:

Wi-Fi Status: displays WI-Fi network current status

IP Address and Socket: IP: 010.010.100.254, Socket 08899

SSID: is CEM70_XXXXXX , password 12345678 .

Wi-Fi ON/OFF: turn the Wi-Fi on or off

Restart : restart the network adapter

Restore to Factory : restore the factory network setting
5.4.13. Power LED Switch
Use this setting to keep the mount power indicator (LED) on during the operation, or turn it off
automatically after 1 minute
Wi-Fi Status
IP Address & Socket
SSID
Wi-Fi ON/OFF
Restart
Restore to factory
Press BACK to exit