© by IONTO-COMED
3
Safety Instructions
Before installing and using the treatment bed, carefully read the instruction
manual and ensure that all directions and instructions contained are fully
understood. It includes important safety information for installation, operation and
maintenance!
If the bed is used for any purpose other than that for which it was designed and as
described in this instruction manual, such use will invalidate the manufacturers
warranty and guarantee!
The control unit may only be opened by the manufacturer or by an expert
approved and authorised by the manufacturer.
When unpacked, check the contents of the delivery to ensure that all parts have
been included and that nothing has been damaged during transit. In the event of
any doubt, please contact our customer service department.
Never use the bed with a damaged mains power supply cable. Do not jam or kink
the cable and do not allow it to rest on any hot object (e.g. radiator, lamp, etc)!
If the mains cable is damaged in any way, immediately disconnect the bed from
the mains power supply. Please consult our customer service department before
using again.
Before connecting to the mains power supply ensure that the voltage (V) shown
on the type plate corresponds with the power supply available!
Under no circumstances may the mains plug be disconnected from the socket
with wet hands. Never attempt to remove the plug from the socket by pulling the
connecting cable!
Do not use in damp surroundings and do not splash with liquid!
In the event of any liquid or foreign body entering the inner of the control unit,
immediately disconnect the bed from the mains power supply! Please consult our
customer service department before using again.
Always isolate from the mains power supply by disconnecting the mains plug
before cleaning!