11
The following page summarizes the step edit options.
Add a New Drum to a Step
Use the PAGE buttons to select the step where the drum is to be added. Press
the pad that corresponds to the sound you want to add. That drum, along with
its volume (how hard the pad was hit), will be recorded into the displayed step.
If you play a pad and there is already a drum event played by that pad on the
displayed step, you will edit the volume rather than add another event. This is
true even if there are several events on the displayed beat, and an event other
than the one to be edited is showing.
Erase a Drum Sound From a Step
Use the PAGE buttons to locate the step containing the drum to be erased.
While holding down the ERASE button, press PLAY. The drum that was being
displayed will be erased.
Change a Drum Sound's Volume in a Given Step
Use the PAGE buttons to select the step containing the drum whose volume
needs to be changed. Either press a number button from 1-8 (1=softest,
8=loudest), use the INC/DEC buttons, or tap the displayed drum pad at the
desired level. If you play a pad to change the level and there are several
events on the same step, the display need not show the specific drum whose
volume you want to edit.
Exit Step Mode
To exit step mode, press STOP, RECORD SETUP, or PLAY.
Page 10: Name The Pattern (Name)
The display shows
NAME
and the current
name (or
NO NAME
if the Pattern has not yet
been named). To name, use the PAGE
UP/DOWN buttons to select the character to
be changed; select the desired character with
the INC/DEC buttons. Lower case and upper
case letters, numbers, punctuation, and
various special-purpose characters are
available. You can also enter numbers with
the number buttons.