Ion Technologies ES45
Effluent Pump
OPERATION MANUAL
Dated: 11/22/2017
Document Name: ES45_OM.indd
Page 2 of 11
www.ionproducts.net
CAUTION:
Rotating machinery,
amputation or severe lacerations can
result. Keep clear of suction and discharge
openings. DO NOT insert fingers into pump
with power connected.
Risk of serious cutting or
amputation exists. Disconnect all power sources prior
to servicing pump. Pump may start without warning.
CAUTION:
Do not modify the cord and plug.
When using the cord and plug, plug into a
grounded outlet only. When wiring to a system control,
connect the pump ground lead to the system ground.
CAUTION: D
o not run the pump dry. Dry
running can overheat the pump (causing burns
to anyone handling it) and will void the warranty.
CAUTION:
The pump normally runs hot. To
avoid burns, allow it to cool for 30 minutes after
shutdown before handling it.
CAUTION:
Submersible sewage pumps are
not approved for use in swimming pools,
recreational water installations, decorative fountains or
any installation where human contact with the pumped
fluid is common. Pump designed to be installed in a
sewage pit or wet location where drainage collects.
WARNING:
Do not throw away or lose this
manual. Keep it in a safe place so that you
may refer to it often for the continued safe operation of
the product.
CAUTION: All returned products must be
cleaned, sanitized, or decontaminated prior
to shipment, to insure employees will not be
exposed to health hazards in handling said
materials. All applicable laws and regulations shall
apply.
WARNING:
Bronze/brass fitted pumps may
contain lead levels higher than considered
safe for potable water systems. Government
agencies have determined that leaded copper
alloys should not be used in potable water
applications.
WARNING:
Installation, wiring, and junction
connections must be in accordance with
the National Electric Code and all applicable state
and local codes. Requirements may vary depending
on usage and location.
WARNING:
Installation and servicing is to be
conducted by qualified personnel only.
CAUTION:
Rotating machinery,
amputation or severe lacerations can
result. Keep clear of suction and discharge
openings. DO NOT insert fingers into pump
with power connected.
WARNING:
Always wear eye protection when
working on pumps. Do not wear loose clothing
that may become entangled in moving parts.
WARNING:
Pumps build up heat and
pressure during operation. Allow time for
pumps to cool before handling or servicing.
CAUTION: Hazardous Voltage can shock,
burn or cause death.
This pump is
not
intended for use in swimming pools or water
installations where human contact with pumped
fluid is possible.
CAUTION:
Risk of electrical shock. To
reduce risk of electrical shock, always
disconnect pump from source before handling.
Lock out power & tag.
WARNING:
Do not use these pumps in
water over 145°F. Do not exceed
manufactures recommended maximum
performance, as this could cause the motor to
overheat.
WARNING:
Make sure lifting handles are
securely fastened each time before lifting.
CAUTION:
Do not lift, carry or hang pump
by the electrical cables. Damage to the
electrical cables can cause shock, burns or death.
Never handle connected power cords with wet
hands. Use appropriate lifting device.
WARNING:
Sump and sewage pumps often
handle materials which could cause illness
or disease. Wear adequate protective clothing
when working on a used pump or piping. Never
enter a basin after it has been used.
CAUTION:
Failure to permanently ground
the pump, motor and controls before
connecting to power can cause shock, burns or
