Ioline Summit, Service Manual

Page: 62 / 139

Flashing Green Y-Axis or Roll Feed Jam Pen caught on edge of paper causing jam.
Ceased y-axis transmission bearing(s).
Ceased servo motor (y-axis or roll feed).
Roll feed transmission mechanical problem.
Blown transistor(s) on logic board (Position Q5–Q8)
Damaged or striped y-axis drive belt teeth.
Damaged y-axis transmission gear assy .
Loose y-axis transmission motor pulley.
Clear paper jam.
Inspect bearing(s) for damage, replace y-axis
transmission bearing(s).
Manually turn motor shaft, if hard to turn replace
servo motor.
Inspect transmission for mechanical problems,
replace damaged parts.
Test transistor(s) w/ohm meter touching D (drain) &
S (source) leads; should read 2.23 mega ohms,
replace if reading is less.
Inspect and replace drive belt if needed.
Inspect gear for damaged teeth, replace damaged
gear.
Inspect and check pulley set screws.
Alternating
Red/Green
Plotter Language Syntax
Error or Major
Communication Error
Wrong plotter language.
Wrong plotter driver.
Wrong data transfer protocol settings for serial port.
File sent before plotter was placed online.
Synchronization problem caused by defective servo
motor encoder.
Defective computer serial port.
Damaged IC RS-232 interface IC on logic board.
Change plotter language in apparel software (DMPL
or HPGL)
Select the driver for Ioline Summit in your apparel
software.
Check port settings from windows control panel
and/or communication settings in your signmaking
software (9600 bps, 8 data bits, 1 stop bit, Xon/Xoff
or Hardware Handshaking).
Abort file, reset plotter power to clear buffer.
Clean encoder disk, replace servo motor.
Perform computer port test from control center
software to verify, if fails replace serial port.
Perform plotter port test from control center software
to verify, if fails replace communication chip
(102822 IC, RS-232 Interface)