Prepare the Daughter Card
Attention!
Attach one end of the ground strap (included) to your
wrist and the other end to a bare metal portion of the printer like
the frame the holds the service station. Keep plastic objects away
from the carriage and logic board assemblies.
a) Remove the three screws indicated.
b) Install the included long spacer in the hole in
the corner of the lower logic board as shown.
13
c)
Install the two short spacers in the holes in
the upper logic board as shown.
d)
Install the long ribbon cables in the daughter
card
e)
Lift the locking collars up from the white
ribbon cable connectors on the bottom of the
daughter card
f)
Insert the ribbon cables into the connector
and press down on the collar to the “closed”
position.
g)
Insert the four longer flex cables into the daughter
card connectors.
NOTE:
It is very important that the conductive side of
the cables align with the conductive pads in the
connector.
h)
Press the locking collar back down after each cable
is inserted.
i)
Insert the shorter flex cable into the white connector
on the bottom of the daughter card as shown. It is
very important that the conductive side of the cable
aligns with the conductive pads in the connector.
Attach the Daughter Card
a)
Lift the locking collars up from the white
ribbon cable connectors on the motor con
-
trol logic board as shown. (long cables
only).
b)
Align the holes in the small daughter card
with the holes in the spacers as shown.
14
Remove the 3
screws
Replace with standoffs
Long
Short
Short
Collar open
Collar Closed
Notch
Long
Short
Plugin the long ribbon cables first
Note:
The black or blue ends at the end of the long cables
should face the middle of the machine.
