2
Cooper Lighting Solutions
IB516117EN
Installation instructions
Installation Instructions - Entri LED
INSTALLATION
Tools Required
Allen Key (3/16”), Phillips screwdriver, electrical wiring tools.
1. Remove the mounting plate from the fixture by
loosening the two socket head cap screws using 3/16”
allen key. (Figure 1.)
2. Loosen the lock nut from the mounting plate.
3. Detach tether from the mounting plate.
4. Mount the mounting plate to the junction box or wall
with gasket contacting wall, away from the luminaire
and secure to the structure with screws (by others).
Mounting plate must be in upright position as specified
by label.
5. Make sure plug at bottom of housing is in place
properly as shown in Figure 1a.
6. Make electrical connections.
7. Re-attach tether to mounting plate.
8. Tighten the lock nut.
ote:
N
Tether must be able to rotate freely; therefore, do
not over tighten lock nut. Fixture must hang from the
tether, NOT from electrical wires.
9. Slide the luminaire-mounting bracket over the top lid of
the mounting plate to nest the hanging mechanism.
Hold luminaire in place while allowing the back surface
of luminaire to rest against wall.
10. Screws must be captured behind lower beveled edge
of mounting plate to ensure luminaire is secure. Press
luminaire firmly against wall and re-tighten the two (2)
socket head cap screws to secure the luminaire to the
mounting plate.
Thru-way Conduit / Battery Back Box
1. Remove the mounting plate from the back of thruway
box by loosening two (2) Allen head screws. (Figure 2.)
2. Mount the mounting plate to the wall using the four (4)
larger holes with required hardware (by others). Plate
must be in the correct upright position.
ote:
N
Unit with a thruway box weighs more than 25
pounds. Therefore, connect mounting plate to the
wall using the 4 larger holes and appropriate anchors/
hardware (not provided).
3. Slide the thruway box mounting bracket over the lid of
the mounting plate.
4. Re-tighten the two (2) Allen head screws to secure the
thruway box to the mounting plate.
5. If used with thru branch wiring, then remove plugs on
side as required and install 3/4” NPS pipe. Seal pipe
with Teflon tape or paste.
6. Remove the thruway box cover from the thruway box
housing by loosening five (5) screws. (Figure 2a.)
Figure 1.
Figure 1a.
Figure 2.
Figure 2a.
Fixture
Lock Nut
Tether
Gasket on
Back
Allen Head Screw (2)
Door Latch
J-Box or Wall
Plug
(Make sure this is in place
before securing fixture to
wall)
Thruway Box Cover
Thruway Box Housing
Mounting Plate
Screws (x4)
Box cover
screws (x5)
Mounting
Plate
Thruway Box Cover
Allen Head
Screws
Mounting Bracket
Mounting
Plate
Mounting
Screws
Allen Head Screws
Thruway Box Housing
Gasket
Mounting
Bracket
Mounting Plate (Secure
to J-Box or Wall)
