As the above picture, if you choose 10s. After you restore factory settings, the time will keep 10s.
Choose the “Adjust”, press the “SETUP” to set the position of electronic motor. When it shows 90
°
but the bar is not in
horizontal position, you could adjust it through this function. It will be ok when the bar is horizontal position when it is 90
°
.
When display shows above picture, choose the electronic motor need to be adjusted. Now it chooses the right motor. Press
the “SETUP” to enter the adjust mode.
After testing the origin, press the “UP” or “DOWN” to check the bars are parallel or not.
When the bars are in parallel position, press “SETUP” and the electronic motor will adjust the reset data, the LCD will
show as below:
When it shows
, the adjustment is finished.
When the electronic motor could not be reset, the LCD shows no reset as follow picture.
Choose “L-Moto” to adjust the left motor and use the same method above.
Choose “Reset”, press the “SETUP” button to enter the restore factory setting. At this time, the display will show a prompt
menu as below to confirm if restore factory setting.
Press “SETUP” to confirm yes, the LCD shows follow process and restore factory settings, the fixture will restar.
Press “MODE” to confirm No, then it will return to last menu.
Choose “MOTO”, press the “SETUP” button to check the motor restore mode, it is normal when it shows “000”, others are
not normal.
Choose “POWER”, press “SETUP” button to check the main board’s voltage, 17-20V will be normal. When turn on the
fixture, if the voltage is higher than 20V, the program would not work and LCD shows “Power high”; if the voltage is lower
than 17V, the program would work but the LCD shows “Power low”, the motor would be abnormal.
Choose “About”, press the “SETUP” button to enter the product information. Press the “UP” or “DOWN” button to scan
the information which include the product model number, product version, motor drive, product update date.
