involight A-000000-05940, User Manual

Page: 21 / 50

20
1.3 Intended use:
This device is a spotlight that can be used to create lighting effects. This device is for professional applications
only, for example on stages, discos, theaters, etc. and is not suitable for room lighting in houses. This product is
approved for use only at 100-240 VAC / 50-60 Hz AC and is designed for indoor use only. When choosing the
place of installation, make sure that the device is not exposed to excessive heat, moisture and dust. Make sure
that there are no cables around. You endanger your own and the safety of others! The ambient temperature must
be between -5 ° C and + 45 ° C. Keep the device away from direct sunlight and radiators. Do not operate the
device until you have familiarized yourself with its functions. Do not allow the device to be operated by persons
who are unfamiliar with the device. Please note that unauthorized modifications to the device are prohibited for
safety reasons. Using the unit differently than described in this manual may damage the product and void the
warranty. In addition, any other use with hazards can cause short circuit, fire, electric shock, crashes, etc..
Part 2: Installation:
Unpack the device and carefully check for damage before using it. Place the unit in a suitable place or hang it on a
suitable crossbar. For suspended installation, the device must be secured with an approved safety cable. In
addition, the mounting bracket must be screwed with the enclosed screws and tightened! Then connect the device
to the power supply and, if necessary, connect a DMX cable and connect it to other devices or to a DMX controller.
More about DMX or Master / Slave operation you can find in Part 3
During installation, the provisions of the BGV C1 (formerly VBG 70) and DIN 15560 must be observed!
Authorized specialists may only carry out the installation!
IMPORTANT! Overhead mounting requires a high degree of experience. This includes knowledge of the load-
bearing capacity, the installation material used and the safety inspections of the material and the projector used,
but the required experience is not limited to this alone. Under no circumstances should you try to perform the
installation yourself if you do not have the appropriate qualification. Instead, commission a professional installer.
Incorrect installation may result in personal injury and / or damage to property.
NOTE!
Use of tripods.
When the unit is mounted on a tripod, be sure that the weight of the unit does not exceed the permissible
carrying capacity of the tripod.
NOTE!
Please note that this device should not be connected to a dimmer.