- DRAFT -
Rev. 1.0 JAB
4
G:\PCTEST LAB\2006 Reports\TRP\Safe Dog Monitor - Part 68\TCB Documents\KZ3-050808 manual.doc
Need Part Number
1.0 Product Introduction
This document contains important information regarding the installation and operation of the
Invisible Fence
®
Brand Safe Dog
®
Monitor. Prior installation of both the signal field wire and
Invisible Fence Brand transmitter is assumed. Review all instructions before installation and use.
1.1 Safe Dog Monitor System Overview
The Safe Dog Monitor is designed to continuously monitor the signal transmission of an Invisible
Fence Brand transmitter and detect when a change occurs in signal amplitude – specifically, the
detection of a wire break condition. The Safe Dog Monitor will also detect an increase or decrease in
the signal amplitude and an RF Link Communication failure between the Loop Sensor and Dialer
Unit. The Safe Dog Monitor is capable of monitoring the signal of the following Invisible Fence
Brand transmitters:
r
ICT 700 Series Transmitters (700, 725, 750, 775)
r
ICT 800 Series Transmitters (801, 802, 810)
r
Invisible Gate
®
r
Invisible Mask
®
II
Before the Safe Dog Monitor is installed, the Invisible Fence Brand pet containment system should
be completely installed and operational.
1.2 Important Precautions and Warnings
Caution:
Never install or service any Invisible Fence Brand equipment during a thunderstorm or
electrical storm, or when thunder or lightning are in your area.
1.3 Required System Components for Installation
The following system components are required for installation of the Safe Dog Monitor.
1. Safe Dog Monitor Loop Sensor [Picture of Loop Sensor]
2. Safe Dog Monitor Dialer Unit [Picture of Dialer Unit]
3. Invisible Fence Brand 700 or 800 Series Transmitter, Invisible Gate, or Invisible Mask II
[Picture of 725 and 801 transmitters]
4. Lightning Protection Device (for the Transmitters) – LP 4100/4200 or Max-Dog [Picture of
4100 and Max Dog]
5. AC Adapter – For transmitter and Loop Sensor power supply [Picture of AC adapter]
6. Y-adapter for Loop Sensor power [Picture of Y-adapter]
7. DC Adapter for Dialer Unit power supply [Picture of Adapter]
8. Phone cable [Picture of phone cable included in system pack]
9. 9-volt battery to for battery back-up on the Dialer Unit [Picture of 9-volt included in system
pack]
10. Optional: 12v Lead acid battery-back-up for transmitter and Loop Sensor
11. Optional: Y-adapter for connecting Loop Sensor (Included in system pack, show picture)
1.4 Product Specifications – Overview
The Safe Dog Monitor consists of two main components: the Loop Sensor and the Dialer Unit. The
Loop Sensor is located in close proximity to the Invisible Fence Brand transmitter. The Dialer Unit
must be located near a working phone connection. The Dialer Unit communicates with the Loop
