www.InvisibleFence.com
7
Wireless Option
1.
Adjust signal field range
•
Determine the desired location and the signal field range required.
-Wireless: 1.5 ft. minimum radius up to 6 ft. maximum radius.
•
With the unit ON, press the RANGE UP (+) or the RANGE DOWN (-) buttons
to increase or decrease the signal field range. The first segment of the range
indicator equals 1 ft. radius of signal fie. Each additional segment
represents approximately 6 inches radius of range.
2.
Verify signal field range
•
Turn the Indoor Shields
®
Plus transmitter ON.
•
Holding the Computer Collar
®
unit, start outside the range and move slowly towards the Indoor
Shields
®
Plus transmitter. Do not touch the correction posts at this time.
•
The Computer Collar
®
unit will beep as it approaches the outer range of the signal field width set in
Step 2. The beeping will be accompanied by a correction.
•
If the Computer Collar
®
unit fails to beep, see the troubleshooting chart found on page 11.
•
Adjust range and/or relocate the Indoor Shields
®
Plus transmitter until desired area is protected
.
3.
Changing the Channel Setting on the Indoor Shields
®
Plus transmitter
1.
Press and release the RANGE DOWN (-) button until no bars
appear on the LCD.
2.
Turn the unit over and remove the bottom lid by rotating
counter-clockwise until in the unlocked position.
3.
Locate the switch for the Channel (A), Channel (B) and Channels (A+B).
(Figure 1)
4.
Select the desired setting. Note: The Indoor Shields® Plus transmitter will not
enter into programming mode if this switch is set to A+B. See
Programming Computer Collar
®
unit
on
Page
9.
5.
Replace the bottom lid making sure that it is aligned in the
unlocked position and turn clockwise until it is in the
locked position.
Note: Ensure the O-ring is in the top housing and seated in the channel before replacing the bottom lid.
Failure to do so may allow moisture leakage and failure of the device.
Locked
Unlocked
Figure
1:
