Inverto IDL 3290S-CI, User Manual

Page: 11 / 144

En
9
BaTTeRIeS:
Batteries are required to operate the remote control (supplied with the unit). To insert the batteries, open the
battery compartment cover on the rear of the remote control. Insert the batteries (AAA size, 2 x 1.5V), by
matching the (+) and (-) markings on the batteries to the markings inside the battery compartment. Replace the
compartment cover.
noTeS:
Spent batteries should not be discarded in your domestic refuse. In most countries, you are legally
•
obliged to ensure spent batteries are properly recycled. They can be disposed of either in special bins
provided in your community, or may be returned to any retailer who sells batteries.
Use the batteries correctly to avoid possible leakage and corrosion. Do not touch the liquid with bare
•
hands, should leakage occur.
Do not use a new battery with an old battery, or batteries of different manufacturers.
•
Do not attempt to recharge the supplied batteries
•
If you do not intend to use the remote for an extended period of time, remove the batteries.
•
If battery leakage occurs, wipe out any liquid inside the battery compartment and insert new batteries.
•
uSIng THe ReMoTe ConTRoL
For best results, point the remote control directly at the receiver while pressing keys
•
Do not place the receiver in a location exposed to direct sunlight or bright fluorescent lighting, as this
•
may interfere with the receiver and cause it not to respond to the remote.
Setup
This short instruction explains the most important functions to ensure that you can directly watch
television with your new digital receiver. Please note, additional adjustments may be required.
ConneCTIng To THe anTenna
Note: Do not connect the digital receiver to the main power yet.
Connect the lNB (low Noise Block) to the digital satellite receiver input
Connect the LNB on the satellite dish antenna directly to the digital receiver using the “LNB in” connector of the
Tuner, by means of a coaxial cable. You may use the loop-through connector to connect to a second receiver.
ConneCTIon To THe TV SeT
The digital receiver and TV set can be connected by means of a SCART cable (supplied), HDMI cable (supplied),
or Composite Video (Yellow) and Stereo Left/Right Audio cable (Red+White).
Simply connect the two ends of the cable you select to use in connecting the receiver to the TV set. The SCART
connection ensures that audio and video signals are transmitted to the TV set in optimum quality.
In case your TV set is equipped only with a CVBS input socket, you can use the CVBS output on the digital
receiver and connect your TV set via cable to provide optimum quality of the video signal. To provide audio
signal to the TV set it is necessary to connect the Audio L/R output on the digital receiver to the audio input on
your TV set.
The HDMI connection is recommended for Digital TV. In case the TV has a HDMI input connector, a special all-
digital interface that provides the highest picture quality, connect the product to the TV with the HDMI cable.
ConneCTIon To a DVD oR VIDeo ReCoRDeR
Just as the TV set, the DVD or video recorder is connected to the receiver via a SCART connection. Use the
VCR SCART socket for this purpose.