33
En
For instance, to setup a configuration for TP1,
tap on the “row of TP1”. A screen as shown at
Figure 51 TP Configuration TP1
will be dis-
played.
Figure 51 TP Configuration TP1
Tap on “LNB Configuration” to configure the LNB
type and LNB related parameters. Almost all pa-
rameters can be chosen per scrolling wheel in this
section.
LNB Type:
You can choose between dCSS Dynamic or
Universal. If you choose Universal you can assign
the satellite position, e.g. “A”.
If you choose dCSS Dynamic you can assign the
satellite position, UB frequency (by typing in the
frequency value), UB number (1 to max. 32) and
the Unicable protocol type (I or II).
See
Figure 52 TP Configuration LNB Type
as
example for dCSS LNB setup.
Figure 52 TP Configuration LNB Type
Tap on “Save” at the bottom to save the config-
uration and to go back to
Figure 51 TP Config-
uration TP1
to set up desired satellite and tran-
sponder for TP1.
At the middle of the screen below the section “Se-
lect Satellite” you have a scrolling wheel whereby
you can choose desired satellite. After the satellite
is chosen you can choose below the section “Se-
lect transponder” the desired transponder.
Hint: Satellite data and related transponder data
are provided by the SatPal™ application.
Summary of Contents for 5415 IDLU-SPAL03-OOOBT-OPP
Page 1: ...Quick Guide SatPal Controller 5415 IDLU SPAL03 OOOBT OPP Item 5415...
Page 2: ...2...
Page 37: ...37 En En...
