Invertek Drives OPT-2-ETHEG-IN, Installation And Operating Instructions Manual

Page: 6 / 20

Optidrive ODP-2ETHEG-IN User Guide Revisions 1.00
6
www.invertekdrives.com
2
Gener
al
In
fo
rm
ati
on
Network Status Indicator
State
Indication
Steady Off Not powered, no IP address
Steady Green Online, one or more connections active
Flashing Green Online, no connections active
Flashing Red Connection timeout
Steady Red Duplicate IP
Flashing Green and Red Self-test
Module Status Indicator
State
Indication
Steady Off No power
Steady Green Operating in normal condition
Flashing Green Drive not configured
Flashing Red Minor fault - Recoverable fault
Steady Red Major fault - Unrecoverable fault
Flashing Green / Red Self-test
COMM
State
Indication
Steady Off Modbus protocol TX/RX inactive
Steady/flashing Yellow Modbus protocol TX/RX active
ERROR
State
Indication
Steady Off Modbus protocol TX/RX Status OK
Steady Red Non-recoverable internal fault – Modbus communications circuit fault
Flashing Red Recoverable Communication fault or configuration error
Link Activity LEDs (P1/P2)
State Indication
P1 Speed Steady Yellow 100Mbps link active
Steady Off 10Mbps or No link
P1 Link Activity Steady Green Valid Link
Steady Off No Link
Flash TX/RX
P2 Speed Steady Yellow 100Mbps link active
Steady Off 10Mbps or No link
P2 Link Activity Steady Green Valid Link
Steady Off No Link
Flash TX/RX
2.5. Power up sequence
At power up the following LED test sequence is performed in parallel:

Network Status Indicator – 0.25 sec RED, 0.25 sec Green

Module Status Indicator – 0.25 sec RED, 0.25 sec Green

COMM – 0.5 sec Yellow, 0.5 sec Off

ERROR – 0.5 sec Off, 0.5 sec RED

‘Running’ state