6
Pin #
Symbol
Description
1
VCANH
CAN High for communication to the vehicle/machine
2
VCANL
CAN Low for communication to the vehicle/machine
3
VWAKE
Wake up input pin – active low to enable discharging
4
VGND
Pack signal ground used to pull Wake up and Interlock low
5
VINTLK
Interlock input pin – active low to enable charging
6
VCANH_BATT
CAN High for module to module communications
7
VCANL_BATT
CAN Low for module to module communications
8
VSUPPLY
Unregulated 24V/36V output – 2A continuous max.
TE Connector P/N: T4131012081-000
Pin Definition (M-24V80-TRX / M-24V90-TRX / M-36V80-TRX)
VSUPPLY (24V/36V) is always on except for during Ship mode and,
Over/Under Temperature and Cell Undervoltage Conditions.
Pin Definition (M-48V60-TRX)
Note: CAN lines in the battery pack DO NOT have internal termination resistance. It is
recommended to properly terminate the system and battery CAN Bus lines following the CAN Bus
termination standards. For any technical questions about properly adding termination resistance,
please contact technical support at [email protected].
Pin #
Symbol
Description
1
VCANH
CAN High for communication to the vehicle/machine
2
VCANL
CAN Low for communication to the vehicle/machine
3
VWAKE
Wake up input pin – active low to enable discharging
4
VGND
Pack signal ground used to pull Wake up and Interlock low
5
VINTLK
Interlock input pin – active low to enable charging
6
VSUPPLY
Aux Power Supply (regulated 15V, <10mA)
7
VCANL_BATT
CAN Low for module to module communications
8
VCANH_BATT
CAN High for module to module communications
Pin Definition
If in doubt, please consult with
Inventus Power Technical Support
([email protected])
on further instructions on the signal
cable connections to the host system.
