inventum SKV1780R, Instruction Manual, Page: 19 / 52

before the first use
3
English •
19
Before you use the appliance for the first time, please do as follows: Carefully unpack the appliance and remove all the packaging
material and promotional stickers. Keep the material (plastic, polystyrene and cardboard) out of reach of children. Check the
appliance after unpacking for any damage, possible from transportation. Place the appliance on a flat and stable surface. Make
sure there is enough open space around the appliance for the intake and/or outlet vents. A minimum clearance of 10 cm is required
between the appliance and any adjacent walls. The appliance needs good ventilation for easy dissipation of heat, high efficiency
of refrigeration and low power consumption. Note: check the climat class of the appliance. When installing the appliance in a
environment that is not suitable, the appliance can not function properly.
Leave the appliance to stand for at least 3 hours before you insert the plug into the socket.
First clean the interior of the appliance. Use warm water and a neutral detergent. After cleaning, rinse the interior with clean water and
rub dry. Leave the appliance to dry for 1 to 2 hours.
DOOR HEIGHT ADJUSTMENT
If the doors of the appliance are not aligned, the height of them can be adjusted. If required, please follow the following steps:
Important: the maximum height adjustment is 5 mm.
Rotate the locking nut clockwise with a wrench for two full rotations to loosen it. You can now rotate the adjusting nut to raise or
lower the height of the door. Once the door is set to your desired position, then tighten the locking nut by rotating it anti-clockwise.
not level
wrench
adjusting nut
locking nut
leveling feet
fixed shaft
right
When the fridge door is too low:
Open the door, use a wrench to rotate the
adjusting nut
anti-clockwise to raise the height of the door. Once the doors are aligned,
tighten the locking nut by rotating it anti-clockwise.
When the fridge door is too high:
Open the door, use a wrench to rotate the adjusting nut clockwise to lower the height of the door. Once the doors are aligned, tighten
the
locking nut
by rotating it anti-clockwise.