To find out the water hardness level in your area, contact your local water company. Adjust the salt consumption according to the
table on the next page.
Note!
Hardness level is adjusted to level 3 as a factory setting.
•
Move the
program selector knob
to the setting
●
(Reset) while the dishwasher is not on (1).
•
After setting the program selector knob on
●
(Reset), press the
Start/Pause
button (2) and keep it pressed down.
•
In the meanwhile switch on the dishwasher by pressing the
On/Off
button (4).
•
Keep the
Start/Pause
button (2) pressed down until the indicator lights turn on and off.
•
After the indicator lights (3) lit up, release the
Start/Pause
button (2).
The control panel shows the latest entered water hardness setting.
•
Set the level of water hardness by pressing the
Start/Pause
button (2). Use the table of water hardness level settings on the
next page.
•
After adjusting the level of water hardness, press the
On/Off
button (4) to confirm and store the setting.
Prior to using the machine for the first time please check whether the electricity and supply water specifications match the values
indicated by the installation instructions for the appliance.
Remove all packaging materials inside the machine.
Fill the salt reservoir and fill up with water until it almost overflows. Set the water hardness setting.
Fill the rinse aid reservoir.
For a good washing result, the dishwasher needs soft, i.e. less calcareous water. Otherwise, white lime residues will remain on the
dishes and the interior of the dishwasher. This has a negative effect on your applinace’s washing, drying and shining performance. For
this purpose, dishwasher salt is used.
• Remove the lower basket and unscrew the cap of the salt reservoir (1 and 2).
• Fill the reservoir before first use with 1 litre of water (3). Place the provided funnel into
the opening and fill with salt till the overflow level (4). It is normal for a little water to flow
out of the opening when doing this.
• Screw the cap back on firmly.
ATTENTION!
• Remove any spilled salt and run a full program to prevent corrosion to the bottom.
• Refill the salt reservoir when the indicator light of the salt reservoir lights up.
before first use
2
FILLING THE SALT RESERVOIR
SALT
SETTING THE SALT CONSUMPTION
30
•
English
4
1
2
3
●
