inventum IOV6032DRVS, Instruction Manual

Page: 26 / 30

THE FITTING OF THE APPLIANCE
• Check that the cabinet and the space for the oven meet the dimension and ventilation requirements.
• Slide the oven into the cabinet. Make sure the housing of the oven does not come in contact with the walls of the kitchen cabinet.
Make sure there is at least 2 mm between the oven casing and the walls of the kitchen cabinet. Make sure the oven is centered
between the walls of the kitchen cabinet. Note: Make sure the cable is not stuck and does not lie on top of the oven.
• Open the oven door and insert the bushings, provided, in the holes on the front.
• Use the provided screws to fasten the bushings to the cabinet. Take care not to over tighten and break the bushing.
• Close the oven door and plug the appliance in.
• The oven is now ready for use.
ELECTRICAL CONNECTION
Check that the voltage in your home corresponds with the voltage printed on the appliance.
These groups in the meter must be secured with at least 16 amps each. The connection cable must have a cross-section of at least
2.5mm² and must have a length of at least 1.5 m. When the cable is too short, you have no room to already connect the oven and place
it against the wall before plugging it in.
INSTALLATION DIMENSIONS
In the drawing below, all the dimensions are displayed in mm. Make sure you use the right drawing for the model you have.
26
• English
installation instructions
13
• The safety during use can only be guaranteed when the hob is installed correctly and according to the regulations. The installer is
responsible for any damage caused by a faulty installation.
• The electrical connection must be made by a qualified electricien. This person is aware of the national and local regulations the
installation must comply with.
• The appliance falls under protection class III and can only be used in combination with a grounding conductor connection. The
manufacturer accepts no responsibility for any malfunction or damage caused by incorrect electrical installations.
• The appliance must be connected to a fixed installation and the means of disconnecting it from the fixed installation must be
installed according to the installation instructions.
• The connection cable must hang freely. Do not tie the power cable or pass it along sharp edges. It must be positioned so that it
does not touch any of the hot parts of the oven.
• The connection point, the wall socket and/or plug must always be accessible.
• The cabinet into which the oven is fitted, must be heat resistant (> 75°C).
• Ensure that the cabinet into which the oven is installed is secure. For example, by mounting it to the adjoining elements.
• Damage caused by incorrect connection, incorrect use or incorrect fitting is not covered by the guarantee.
Attention: any change to the appliance’s interior, including fitting and changing the power cable, must only be performed by a
qualified electricien.