installation instructions
7
• The safety during use can only be guaranteed when the hob is installed correctly and according to the regulations. The
installer is responsible for any damage caused by a faulty installation.
• The electrical connection must be made by a qualified electricien. This person is aware of the national and local
regulations the installation must comply with.
• The appliance falls under protection class III and can only be used in combination with a grounding conductor
connection. The manufacturer accepts no responsibility for any malfunction or damage caused by incorrect electrical
installations.
• The appliance must be connected to a fixed installation and the means of disconnecting it from the fixed installation
must be installed according to the installation instructions.
• The connection cable must hang freely. Do not tie the power cable or pass it along sharp edges. It must be positioned so
that it does not touch any of the hot parts of the oven.
• The connection point, the wall socket and/or plug must always be accessible.
• The cabinet into which the oven is fitted, must be heat resistant (> 100°C).
• Ensure that the cabinet into which the oven is installed is secure. For example, by mounting it to the adjoining elements.
• Damage caused by incorrect connection, incorrect use or incorrect fitting is not covered by the guarantee.
Attention:
any change to the appliance’s interior, including fitting and changing the power cable, must only be performed
by a qualified electricien.
problems & solutions
6
Problem
Solution
The oven lamp is not lit.
Replace the oven lamp according to the instructions.
The oven is not heating up.
- Has the correct temperature and oven function been set?
- Is the door of the oven closed properly?
The display is not lit.
- Is the energy saving mode activated? Press any key to activate the LED display.
Removing and installing the oven door
The oven door can be removed to clean the interior and the door easily.
REMOVE
• To remove the oven door, open it completely.
• Lift the two levers at the hinges. If necessary use a small screwdriver.
• Carefully close the door as far as the first stop, caused by the raised levers.
• Lift the door upwards and outwards, to remove it from the mountings.
INSTALL
• Place the hinges of the oven door in the mountings. Make sure the door is aligned
straight.
• Lower the two levers at the hinges back.
• Close the oven door.
Replacing the oven lamp
Before proceeding, disconnect the appliance from the power line to avoid the possibility of
electric shock.
• Unscrew the glass cover of the lamp.
• Replace the light bulb with a new equal bulb (25 W, 220-240V, T300°C halogen lamp).
• Refit the glass cover.
• Plug the appliance in.
24
•
English
