inventum IOM6072RK, User Manual

Page: 37 / 80

REMOVING THE COVER OF THE DOOR
1. Push the pins (A) on each side of the door.
2. Remove the cover (B).
Note:
When the cover is removed, the glass panels inside the door are also accessible.
3. After cleaning, install the cover again. Refer to section 'Installing the cover of the door' .
INSTALLING THE COVER OF THE DOOR
Caution:
Make sure that the glass panels are installed correctly.
1. Carefully push the cover (A) in the door until you hear a click.
CLEANING THE KNOBS
Caution:
Do not clean the knobs in a dishwasher.
Caution:
Do not use an abrasive cleaning agent.
1. Pull the knobs to remove them.
2. Clean the knobs. Use warm water and a mild cleaning agent.
3. Dry the knobs. Use a soft cloth.
4. Carefully push the knobs back in the control panel.
REPLACING THE LAMP
Warning:
Make sure that the appliance is cooled down.
Preliminary requirements
1. The appliance is switched off.
2. The appliance is disconnected from
the mains supply.
• Halogen lamp (25W, 230V, T300°C)
Procedure
1. Turn the glass cover (A) counter-clockwise to remove it.
2. Carefully pull the lamp (B) to remove it.
3. Replace the lamp.
4. Install the glass cover.
Closing requirements
1. Connect the appliance.
(Figure 12)
(Figure 13)
(Figure 14)
English • 37