English
•
23
installation instructions
8
Before installation, read the instructions carefully.
• Fit the larder in stable kitchen units only with sufficient ventilation (figure B and C).
• If necessary, reverse the door according to the instructions.
• Check the installation dimensions of your model according to figure C.
1 See figure A for the necessary attachment components.
2 Insert the trim flap
1
into the slot and screw by screws
6
(figure D).
3 Pass the power cord through the ventilation shaft and position it so that the appliance could be easily plugged in once it has
been installed (figure B and C).
4 Take out the trim gasket
2
located on the side panel of the appliance and stick it on the reverse side of the door hinges of the
appliance (figures D and E).
5 Raise the appliance and slide into the kitchen unit.
6 Push the appliance to the reverse side of the door hinges providing that the trim gasket
2
covers the space between the
appliance and the kitchen unit.
7 Allign the front feet with the front surface of the kitchen unit (figure F).
8 Screw the front feet by using screws
5
(figure F).
9 Screw the trim flap
1
to the kitchen unit using screws
5
(figure G).
10 Screw the guides
3
to the appliance door with screws
6
(figure H).
11 Lean the appliance door to the unit door as it is opened at the right angle 90°.
12 Slide the rails
4
into the guides
3
aligning the groove (figure H).
13 Screw the rails
4
to the unit doors with screws
5
(figure H).
14 Set 1-2 mm gap on the handle side between the unit itself and the unit doors by adjusting the guides
3
(figure H). That is vital for
the appliances performance.
IKK1221S-1021S-0881S-instructions.indd 23
27-8-2014 9:42:22