INVENTOR P3F-50L, User Manual

Page: 12 / 128

12
EN
7. WatEr tanK & Drain hOSE
There are three ways to remove collected water. Before proceeding ensure that you
have switched off and unplugged the unit.
1. Usage of the water tank
When unit is OFF and the tank of the dehumidifier is full, the full indicator will be lit
and the display will read P2. Additionally, when the unit is on and the tank is full, the
compressor stops operation followed by the fan a few minutes later. The full indicator
will flash and the display will show P2.
• Slowly remove the bucket. Grip the handle with caution and carefully pull outwards so
the water does not overflow. Do not place the tank on the floor because the bottom of
the tank is uneven. Doing so the tank will fall and the water will be spilled on the floor.
• Empty the water from the tank and place it again in to the device. The water tank, must
be securely and properly placed, for the dehumidifier to operate.
• When the water tank is re-installed the unit will automatically restart.
• When you remove the tank, do not touch any parts inside the unit, as you may damage
the device.
• Be sure to gently place the tank into the dehumidifier.
• Do not drink or use the collected water from the device.
• Wipe any excess water on or in the unit when removing the tank.
• When bucket is removed if the pump hose
disconnects, before replacing the bucket the pump
hose must be reconnected
• If the bucket is removed during operation, the
compressor and the fan turns off, the unit will beep and
Eb will appear on the digital display.
• If the bucket is removed when unit is Off, the unit will
beep and Eb will appear on the digital display.
Pump hose
drops
Reinstall pump
hose properly