SECTION 6—FRONT RIGGINGS
Van Seat
24
Part No 1143195
Adjusting the Angle of the Manual Center Mount
Footrest
WARNING
While the wheelchair is moving, minimum ground clearance for the front rigging is
three inches. If the wheelchair is not moving, the front rigging MUST maintain a
minimum of one inch ground clearance - otherwise personal injury and damage may
result.
NOTE:
For
this
procedure,
refer
to
FIGURE 6.8
on
page 23
and
FIGURE 6.9.
1. Engage
the
release
lever
with
one
hand
(not
shown)
and
move
the
center
mount
footrest
to
the
desired
angle
with
the
other
hand.
NOTE:
Refer
to
FIGURE 6.8
on
page 23
for
the
location
of
the
release
lever.
2. Disengage
the
release
lever
(not
shown)
to
lock
the
center
mount
footrest
in
the
new
position.
FIGURE 6.9
Adjusting the Angle of the
Manual Center Mount Footrest
Adjusting the Footplate Angle
After 2/14/07
NOTE:
For
this
procedure,
refer
to
FIGURE 6.10.
1. Loosen,
but
DO
NOT
remove,
the
two
rear
mounting
screws
and
side
mounting
screw.
2. Move
the
footplate
to
the
desired
angle.
3. Tighten
the
two
rear
mounting
screws
and
side
mounting
screw
to
secure
the
footplate
in
the
desired
position.
4. Repeat
STEPS
1
and
2
for
the
other
footplate.
FIGURE 6.10
Adjusting the Footplate
Angle - After 2/14/07
Footplate
Center Mount
Footrest
Center Mount
Front Rigging
Footplate
Side Mounting
Screw
Rear Mounting
Screws
