Invacare Storm 4 Series, Service Manual

Page: 73 / 102

Service
6. Position protective tube for cables completely from
outer side.
Fig. 6-73
7. Secure protective tube with a tie wrap (1) on cable
guide.
8. Proceed with Installing on Lifter Column Type B - Part
2 , page 73 .
Fig. 6-74
Installing on Lifter Column Type B - Part 2
1. Run cable bundle, including protective tube for cables,
through opening in front shroud (2).
2. Secure cable bundle with tie wrap under shroud.
Fig. 6-75
3. Raise and lower seat several times while closely
watching cable bundle. The cable bundle must not get
trapped, stretched or crushed. The cable bundle must
move sideways, as shown in the following illustrations.
The drive motor must not be touched by cable bundle.
Pay attention to areas where cable bundle
might get crushed or touch motor.
Fig. 6-76 Lifter column completely extended
1533060-N 73