SECTION 2—ASSEMBLY
Part No 1141431
11
Reliant™ 440
SECTION 2—ASSEMBLY
Assembling the Patient Lift
WARNING
Tighten mounting screws securely. Failure to do so may result in bodily injury or
damage to the lift.
NOTE:
For
this
procedure,
refer
to
FIGURE 2.1
on
page 12.
NOTE:
The
Reliant
440
is
packed
partially
assembled
for
shipping
purposes.
1. Remove
all
contents
from
the
box
and
place
the
unit
on
a
workbench
or
table.
2. Remove
the
two
mounting
screws,
washers,
and
locknuts
connecting
the
mast
to
the
base
(Detail
“A”).
3. Remove
the
mast
from
the
base.
4. Position
and
re
‐
attach
the
mast
to
the
base
using
the
two
mounting
screws,
washers,
and
locknuts
removed
in
STEP
2
(Detail
“B”).
Securely
tighten.
5. Insert
the
pins
of
the
rod
ends
up
through
the
tabs
on
the
base
(Detail
“B”).
6. Attach
the
pins
of
the
rod
ends
to
the
tabs
using
the
two
locknuts
and
washers.
Securely
tighten.
7. Cut
the
cable
tie
securing
the
actuator
(Detail
“C”).
8. Swing
the
actuator
forward
so
that
it
is
out
of
the
way.
9. Swing
the
boom
up
and
over
to
the
front.
10. Attach
the
push
handle
to
the
back
of
the
mast
using
the
two
mounting
screws,
locknuts,
and
washers
which
are
provided
(Detail
“D”).
11. Attach
the
kneepad.
Refer
to
Attaching
the
Kneepad
on
page 13.