REA® ASSIST
26
1.
3.
C
2.
B
A
Transport
The Rea® Assist is easy to prepare for transport.
1. Backrest
Remove the back cushion by pulling it forwards,
thus separating the Velcro strops.
Loosen both knobs (A) and pull the backrest
directly upwards. Lay the backrest on the seat,
where it can remain during transport of the
wheelchair. Where applicable, detach the push
handles. Be careful with the cables that run from
the rear wheel to the push handles.
When detaching the backrest and placing it on the
seat, try to make sure that the cables hang freely.
2. Push handles braced.
Loosen the two knobs (B). The height of the
handles can be adjusted simply by pulling the
handles upwards or pushing them downwards.
It is important that you
do not mix up the
upper and lower
knobs
on the back of the
backrest. The lower knobs lock the backrest to
the chair, and if these are loosened by mistake,
the safety of the chair may be jeopardised!
The push handles brace must not be pulled up
so that it protrudes more than 19 cm over the
top edge of the attacthment.
Do not touch these knobs!
3. Legrests
The legrests are loosened by pushing the lever (C)
forwards whilst turning the legrests outwards. You
can then simply lift off the legrests.
Summary of Contents for Rea Assist
Page 1: ...Rea Assist Manual English...
