9
INSTALLATION OF ON CHAIR MOUNTING KIT SEAT
MOUNTING HARDWARE (FIGURE 7)
NOTE: Refer to GENERAL and INSTALLATION WARNINGS in the SAFETY SUMMARY in this instruction
sheet.
NOTE: The wheelchair hardware consists of two (2) fixed release clamps and two (2) twist release
clamps. The wheelchair hardware must be mounted facing up (on top of the seat rails) with the twist
release clamps at the front and the fixed release at the rear of the seat rails.
NOTE: The seat mounting brackets should be placed on the seat rail without interfering with other
wheelchair accessories.
1. Install the L brackets onto the ContourU seat. Refer to INSTALLING THE SEAT L
BRACKETS in this instruction sheet.
2. Install the J brackets onto the L brackets. Refer to INSTALLING/ADJUSTING THE SEAT J
BRACKETS in this instruction sheet.
3. Position the ContourU seat onto the seat rails in the desired location.
4. On the seat rails, mark the front edge of the two (2) front J brackets and the rear edge of
the two (2) rear J brackets as shown in DETAIL "A" of FIGURE 7.
5. Remove the mounting screw, washer, lock washer, and internal threaded mounting screw
from one of the fixed release clamps.
6. Install the fixed release clamp onto the seat rail so that the open end of the fixed release
clamp is facing the front of the wheelchair and aligned with the mark made in STEP 4 as
shown in DETAIL "B" of FIGURE 7.
7. Using the mounting screw, washer, lock washer, and internal threaded mounting screw,
secure the fised release clamp to the seat rail. Securely tighten.
8. Repeat STEPS 5-6 to install remaining fixed release clamp.
9. Remove the mounting screw, washer, lock washer, and internal threaded mounting screw
from one of the twist release clamps.
10. Install the twist release clamp onto the seat rail so that open end of the twist release clamp
is facing the rear of the wheelchair and is aligned with the mark made in STEP 4 as shown
in DETAIL "B" of FIGURE 7.
11. Using the mounting screw, washer, lock washer, and internal threaded mounting screw,
secure the twist release clamp to the back cane. Securely tighten.
12. Repeat STEPS 8-9 to install remaining twist release clamp.
13. Install the ContourU seat on to the wheelchair. Refer to INSTALLING/REMOVING THE
CONTOUR U SEATING SYSTEM SEAT in this instruction sheet.
14. If seat depth and or angle adjustments are necessary refer to ADJUSTING THE
CONTOUR U SEATING SYSTEM SEAT in this instruction sheet.
