14
ADJUSTING THE CONTOUR U
SEAT HEIGHT (FIGURE 11)
NOTE: There are six (6) height adjustments avail-
able on the ContourU seat with a seat pan.
NOTE: There are twelve (12) height adjustments
available on the ContourU seat with a wood back.
Six (6) mounting positions with the L brackets fac-
ing the front of the wheelchair and six (6) mounting
positions with the L brackets facing the rear of the
wheelchair.
NOTE: All four (4) J brackets must be adjusted to
the same height unless seat angle adjustments are
necessary. Refer to ADJUSTING THE CONTOUR U
SEATING SYSTEM SEAT ANGLE in this instruction
sheet after performing this procedure.
1. If necessary, remove the ContourU seat.
Refer to REMOVING/INSTALLING THE
CONTOUR U SEATING SYSTEM SEAT
in this instruction sheet.
2. Remove the two (2) mounting screws and
locknuts that secure the J bracket to the L
bracket.
3. Align two (2) mounting holes of the J
bracket with two (2) mounting holes of
the L bracket to acquire the desired
height as shown in DETAIL A of
FIGURE 11 .
4. Reinstall the two (2) mounting screws and
locknuts that secure the J bracket to the L
bracket. Securely tighten.
5. Repeat STEPS 3-4 to adjust the remaining
three (3) J and L brackets.
6. Reinstall the ContourU seat onto the
wheelchair. Refer to REMOVING/IN-
STALLING THE CONTOUR U SEATING
SYSTEM SEAT in this instruction sheet.
7. Ensure the ContourU seat is set to the
desired height. If necessary repeat STEPS
1-7 until desired height is achieved.
ADJUSTING THE ON CHAIR MOUNTING KIT MOUNTING
HARDWARE FOR THE CONTOUR U SEATING SYSTEM
SEAT
NOTE: Refer to GENERAL and INSTALLATION
WARNINGS in the SAFETY SUMMARY in this in-
struction sheet.
DEPTH ADJUSTMENTS
Pan or Wood Back
Additional Positions
For Wood Back Only
FIGURE 11 - ADJUSTING THE
CONTOUR U SEATING SYSTEM
SEAT HEIGHT
Locknuts
Mounting Screws
J Bracket
Mounting Holes
L Bracket
DETAIL "A"
