10
1)
2)
1)
2)
B
A
C
1. Connect the cables of the bed end motors (head and foot end) directly to the control box.
2. Only 4 - sectioned beds: The plug of the thigh motor must be directed through the opening of the supporter
for the backrest motor and then be connected to the control box.
3. Connect the mains cable to the 230 V plug.
4. Run the motors of the bed ends to their top position.
. Place the motor cable of the foot end on the hook at the foot end.
. Run the backrest to its top position.
7. Place the head end motor cables on the 4 hooks at the head end.
8. Fasten the safety clip to the control box.
When working with the foot end, note that there is a risk of getting squeezed during transport since the adjustable
leg section is not firmly locked. Remember to remove the plug from the mains socket when moving the bed.
4. Fitting the accessories
(Illustration 3)
Fitting the siderail, model 5525/5526/5529
The siderail must be mounted with the release system at the head of the bed.
The fork links on the siderail must be mounted according to
the instruction on the siderail.
Tighten the siderail with 2 thumb screws.
Mounting of BRITT II/III/IV (Classic bed ends)
1. Raise the bed about 1/3.
2. Dismount the stop-knobs using the thumb screws (C).
3. Remove protection tape at the locking pins at both
ends of the siderail.
4. Fit one end at a time. Lift the lower wooden bar
and guide the metal bow to the bed end rail (A).
. Press the locking pin of the siderail with a finger (B).
. Guide the siderail to the bed end and pull up the wooden
siderail bar, until the locking pin locks with an audible click.
7. Mount the stop-knobs using the thumb screws (C).
There is a risk entrapment on assembly and operation of the siderails.
Fitting the lifting pole
Remove the plug from the lifting pole tube at the head end of the bed where the lifting pole is to be placed.
Insert the lifting pole into the lifting pole tube and fix with the thumb screw.
0 - cm
2 cm or more
