Invacare Comet Series ALPINE Plus, User Manual

Page: 28 / 64

Invacare® Comet Series
The mounting brackets (1) for attaching the belt, are located under
the seat (the figure shows only the left hand side).
1. Take hold of the belt mounting and hold it in front of the hole in
the mounting bracket.
2.
Position the bolt (1), screw the nut on from the other side and
tighten with a wrench.
3.
Repeat steps 1–2 on the opposite side of the seat with the
remaining side of the posture belt. Check to ensure that the nut
is tightened properly on the bolt.
5.2 Rollator bracket
Your scooter can be fitted with an optional rollator bracket. Only
the following rollators, which have been approved by Invacare, can be
transported using this bracket:
•
Dolomite Jazz 600
•
Dolomite Legacy 600
•
Invacare Banjo P452E/3
The maximum permitted rollator weight is 9 kg.
CAUTION!
Risk of tipping as a result of altered center of
gravity
The center of gravity of the scooter shifts towards the
back as a result of attaching the rollator. The maximum
safe angle of incline is thereby reduced by up to 2°.
– Note that gradients that you would normally be able
to negotiate may now be too steep and the scooter
could tip. Do not attempt to climb or descend such
gradients.
5.2.1 Attaching the rollator
Dolomite Jazz 600
28 1603455-A