Settings and Adjustments
A
B
C
D
A
16 inch rear wheel
B
Front position for the rear wheel
C
Middle position for the rear wheel (standard position)
D
Rear position for the rear wheel
3.13.2
Adjustment 22–24 inch wheels
Azalea:
Azalea Max:
A
B
A
B
Tool: 24 mm fixed spanner
Horizontal position
1.
Loosen the rear wheel attachment
A
with a spanner.
2.
Move the housing to the required position on the rear wheel
position plate
B
, either further forwards or backwards.
3.
Check the position of the brakes, and that the user can move the
chair safely in its new balance position.
For the Azalea Max there are three different horizontal
positions for the rear wheel.
Make sure that you tighten the housing securely when you
have decided on the position.
The axle housing should be tightened with a manual and
dynamometric wrench calibrated to 40 Nm.
Height
1.
Loosen and remove the attachment
A
using a spanner.
2.
Move the rear wheel attachment to the required height.
3.
Re-tighten the attachment.
If the position in height is changed, the size of the rear wheels
must also be changed.
See section: 7.7 Seat height tables, page 35 for correct positioning
of the rear wheel.
3.14
Central legrest
3.14.1
Adjusting the height of the central legrest
You can adjust the height of the legrest in the following two ways:
A
B
Alternative 1:
1.
Loosen the screw
A
on the front of the telescopic tube.
Tools: 5 mm Allen key
2.
Place the legrest in the desired position.
3.
Secure the legrest into place using the Allen screw.
Alternative 2:
1.
Loosen the Allen screw
B
by the legrest attachment.
Tools: 5 mm Allen key
2.
Adjust to the desired height.
3.
Re-tighten the screw
3.14.2
Adjusting the depth of the central legrest
A
1.
Loosen the frontal screw
A
on the side of the tube.
Tools: 5 mm Allen key
2.
Adjust the depth of the foot plate.
3.
Tighten the screw
A
when you have found the desired depth.
4.
Repeat this procedure to adjust the depth of the other foot plate.
3.14.3
Adjusting the angle of the central legrest
A
1.
Loosen the adjustment knob
A
.
2.
Hold the foot plate with the other hand.
3.
Adjust to the appropriate leg angle.
4.
Re-tighten the knob.
1580313-B
25
