Invacare Alegio NG, User Manual

Page: 12 / 108

Invacare® Alegio NG
Mounting
1. Lift the upper bar in one end of the side rail. The
release buttons
C must face up/outwards.
2. Press in the locking pin
A
in the end of the side rail.
3. Guide the three gliding shoes B (in the end of the side
rail bars) up into the bed end guideways, until they have
all passed the locking pin
D .
4. Repeat steps 2 and 3 to mount the other side of the
side rail.
Dismounting
1. Lower the side rail.
2. Lift the lower bar, in one end, to make the locking pin
D visible and press it in with a screwdriver.
3. Lower all three bars, until they are out of the guideways.
4. Repeat steps 2 to 3 to dismount the other end of the
side rail.
3.7.3 Lisa side rail
Installing the side rail
WARNING!
Risk of entrapment / suffocation
The user can get trapped or fall out of the bed if
the side rail is not correctly mounted or damaged.
– Make sure that all gliding shoes are correctly
guided into the bed end guideways.
– Make sure that the locking screw and tab
are properly installed at the bottom of the
guideways.
Assembling the gliding system
1.
Push the pawl A from the backside, through the glider
B
and make sure it locks with an audible click.
2. Do the same for all four pawls in each glider.
Attaching the gliding system and installing the side rail
1. Raise the bed to 1/3 of full height.
2.
Loosen the screw and tab at the bottom of the
guideways on one of the bed ends and push the glider
halfway up into the guideway until it attaches with an
audible click.
3.
Push the upper side rail onto the two upper pawls.
4.
In the other end of the side rail bar; push the two upper
pawls into the end of the bar.
5.
Push the attachment into the guideway until it attaches
with an audible click (=properly engaged in the lower
position).
6. Mount the lower side rail bar in both ends as in step 4.
12 1561872-F