SECTION 8—ADULT BACKS
41
FIGURE 8.3
Removing/Installing the Back Canes
Removing/Installing the Spreader Bar
NOTE: For this procedure, refer to FIGURE 8.4 on page 42.
NOTE: This procedure only applies to systems without Contoura backs that omit upholstery.
Removing
1. Remove the two mounting screws and locknuts securing the spreader bar to the back
canes.
2. Remove the spreader bar from the back canes.
Installing
NOTE: Before installing a new spreader bar, read adjusting spreader bar width. Refer to Adjusting
Spreader Bar Width on page 42.
1. Position the spreader bar against the back canes.
2. Loosely install the two mounting screws and locknuts hold the spreader bar against
the back canes.
3. Adjust the position of the spreader bar until it is parallel with the ground/floor.
4. Torque the mounting screws to 13 ft-lbs ± 20%.
Lower Hex Screw
Upper Hex Screw
Washers
Cane Bracket
Back Cane
Locknuts
Slot
