Invacare Action 2NG, User Manual

Page: 20 / 60

Invacare® Action 2 NG
Adjusting the height
1. Loosen the screw
B
with 5 mm Allen key in the groove
C of the armrest tube.
2. Move the armrest upwards or downwards until you
reach the desired height, while keeping screw
B in
place (at the top edge of the holder).
3. Tighten the screw
B
(5–6 Nm).
4. Perform the setting on both sides.
3.8.2 Armrest, foldable and removable
Folding
1. Grip the armrest by the armpad or by the front curve
and fold it back.
Front removing
1. Press and hold the armrest release push pin A at the
front.
2. Remove armrest from armrest socket by pulling straight
up and fold it back.
Front fitting
1. Push the armrest down and until the front release
button
B snaps into its armrest socket hole.
2. Ensure button protrudes fully through socket hole.
Rear removing
1. Remove armrest from armrest bracket D by pulling
straight up on the armrest.
Rear fitting
1. Position armrest support C over rear armrest bracket D .
2. Push the armrest down until a clear “click” is heard
when it’s locked into the armrest bracket
D .
3.9 Leg rests
WARNING!
Risk of injury
– Never lift the wheelchair by the footrest
supports or leg rests.
CAUTION!
Risk of pinching or crushing fingers
There are swing mechanisms where you could
trap your fingers.
– Be careful when using, swinging, disassembling
or adjusting these mechanisms.
IMPORTANT!
Risk of damage to the leg rest mechanism
– Do not place anything heavy, or let children
sit on the leg rest.
20 1608216-C