Part No. 1110545
27
A-4
REAR SEAT-TO-FLOOR HEIGHT ADJUSTMENT (FIGURE 3)
WARNING
WARNING
WARNING
WARNING
WARNING
After making adjustments, always make sure that ALL parts are properly
tightened BEFORE using the wheelchair.
NOTE: All A-4 wheelchairs are manufactured with the REAR seat-to-floor height 1-inch lower than
the FRONT seat-to-floor height. REAR seat-to-floor height adjustment slots are in 1/2-inch increments.
The number of available adjustment slots depends on the configuration of the wheelchair. Refer to
specifications in this manual for complete information.
1. Remove the two (2) screws, nylon washers and locknuts that secure the seat frame
to the wheelchair frame.
2. Reposition the seat frame so the mounting hole is aligned with the desired mounting
position in the wheelchair frame.
3. Resecure the seat frame to the wheelchair frame with the two (2) screws, nylon
washers and locknuts.
Screw
Locknut
Seat Frame
Wheelchair
Frame
DETAIL "A" - MOUNTING
POSITIONS
Mounting
Positions
FIGURE 3 - REAR SEAT-TO-FLOOR HEIGHT ADJUSTMENT
SECTION 4
FRAME
FRAME
Nylon
Washer
