Intrise AIR ZERO AZ, User Manual, Page: 22 / 44

22
15. MAINTENANCE
15-1 Cleaning of nozzle
For many case, as an easy method, you can clean the nozzle if you set the work at V1 MODE and
push out any gas through nozzle. But, if you can not clean the nozzle by that method, please do as
follows ;
14) To disassemble the nozzle – Loosen BOLT TO FIX NOZZLE and separate VACUUM HOSE
and pull out NOZZLE
15) To clean the nozzle – Put compressed air into NOZZLE, or put NOZZLE in warm water for a
while and then wash its inside.
16) To assemble the nozzle – Do the reverse of 1). At this time, by using BOLT TO CONTROL
THE HEIGHT OF NOZZLE ’ S FRONT, set the front of NOZZLE at the middle of upper sealing
bar and lower sealing bar during the upper sealing bar ’ s 2
ND
going down.
15-2 Cleaning of vacuum and gas line
Put compressed air into VACUUM HOSE, or put VACUUM HOSE in warm water for a while and then
wash its inside.