EN-V233 – 5009 – AB – 07-0106-EN (EEN-REC4)
Real Time Receiver and RW Installation and use Page 8 / 11
DIP SWITCHES FEATURE
A)
C
ONCEPT
The Dip Switch function enables RW and Real Time modes to be opened independently.
The receiver saves a Dip Switch code using the detection push-button. The remote control
with the same Dip Switch code will now open the door.
Switch 5 in the ON position activates this feature.
The receiver can save up to 10 different Dip Switch codes.
B)
H
OW DOES IT WORK
?
The receiver recognises one of the Dip Switch codes on an Intratone remote control, and
authorizes the entrance or exit to open.
Only Intratone remote controls made later than 2014 and with the Intratone Dip Switch
software/hardware installed can use this mode.
C)
SAVING DIP SWITCH CODES
1) Press once on the “Dip Switch” detector button.
2) The LED above the button remains lighted. You have 10 seconds to press one of the
buttons on a pre-programmed remote control with “Dip Switch”.
3) The remote has been saved when the LED begins to flash.
4) To exit detection mode: Press once on the push-button or wait for the LED to switch off.
D)
OPENING WITH DIP SWITCH CODES
From then on, each remote control with a “Dip Switch” code saved by the receiver will be
authorized to open doors.
Note:
This is true independent of RW or Real Time modes.
E)
R
ESET DIP SWITCH CODES
(RAZ)
1) Press and hold the “Dip Switch” detector button for 3 seconds.
2)The LED above the button flashes quickly:
10 second waiting time to confirm RAZ.
2) Press PB once (before end of 10s wait)
RAZ confirmed and return to normal mode.
3) Following this, all “Dip Switch” codes are deleted. No remote control will operate in
this mode.
It is impossible to cancel a specific remote or “Dip
switch” code in
“Dip Switch” mode: it’s all or
nothing!
