9
Calibrating the Screen
1. Start the vehicle and enter the RGB source. Prodigy 1.2: Press the soft “Navigation” key
in the bottom right and corner of the screen. Prodigy Mini: Press and hold the “Screen
Off” key until it switches to the Prodigy HMI.
2. NOTE: On this system, it is usually not necessary to calibrate the touch screen. Only
go through this process if the touch seems to be off. If using the Prodigy 1.2 insert the
included Intraphex
TM
mouse into the USB port on Connector Two (Con 2). Only one port
will work. You may need to remove the WIFI dongle to get the correct port. If using the
Prodigy Mini, try either port, one will work. Use the mouse to enter the “Settings” menu.
You will be prompted to enter a password. The password is “7777,” then press OK. Use
the mouse to click the calibration icon. You will see a white screen with a crosshair in the
center. Use your finger to press and release that point (Best results are from the driver’s
side of the vehicle). The crosshair will move to four (4) additional locations, then press
“Exit.” You may now remove the mouse. If using the P1.2 system, be sure to re-install the
WIFI dongle into the same port.
