© Intralot Inc. WinStation (TVM) Terminal Manual – October 2017
Page 16
2.12.
Load and Unload Paper Roll
Load Paper Roll
Place the paper roll on the white
spindle. Make sure it is fully on
(over the holding lip at the end of
the spindle) this will make sure it
feeds correctly, does not fall off,
and the sensor can detect when the
paper is low.
Feed the paper from the bottom of
the roll.
Pull enough paper from the roll to
reach the printer, feeding it up the
back of the printer unit through the
large square hole and then under
the green cutter bar.
Push the green cutter bar back and
up to open the cutter head.
Feed the paper under the cutter
head so that the paper will show up
when you push the cutter back
down but not past the black
lip/guide it will feed through in the
front.
Close the cutter head by pushing it
down and snapping it into place.
The paper will feed and cut a short
piece of paper automatically. If not,
try reloading and make sure the
paper is straight and centered (not
up against either side) before
pushing down the green cutter bar.
Unload Paper Roll
Push the cutter bar (green lever)
back and up to release the paper
feed.
The paper usually drops out of the
paper feed. If not, pull the paper
back to remove it from the paper
feed.
Remove the roll from the ticket roll
stock spindle. Set the used roll
aside if reloading; discard if
replacing with a new roll.
