Intrade Line JS-981PQ, Original Instruction Manual

Page: 8 / 22

original instructions
Page 8 of 22
Fig. D
Fig. E
Never start or stop the spray gun while it is aimed at the
surface to be sprayed. Evenly control the speed of
movement of the spray gun. A fast speed of movement
over the surface will give a thin coat and a slow speed
will give a heavy coat. Apply one coat at a time. If a
further coat is required, make sure you observe the
manufacturers drying time recommendations before
applying a second coat. When spraying small areas,
keep the output control on a low setting. This will avoid
using too much paint and prevent overspray. Where
possible, avoid stopping and starting when spraying an object. This can lead to too much, or
not enough paint being applied. Do not tip the spray gun to more than 45°.
4. MAINTENANCE
Make sure that the plug is removed from the mains when carrying out maintenance work on the motor.
The machines have been designed to operate over a long period of time with a minimum of maintenance.
Continuous satisfactory operation depends upon proper machine care and regular cleaning.
Troubleshooting
Malfunction Cause Solution
Motor hums but does not
spray or irregular
spraying.

Worn swirl head

Pick up pipe not in the right position

Blocked pick up pipe

Blocked nozzle

Blocked filter

Control knob needs adjustment

Replace swirl head.

Re-adjust pick up pipe.

Clean with thinner.

Clean nozzle.

Clean with thinner.

Adjust.
Atomization is not good.

Volume adjustment is not correct.

Paint too thick

Adjust.

Check viscosity of the paint.
Fig. E