Mechanical installation
4
i
j
| BA 14.0190 - EN | 02/2007
23
1. Hammer the pins (12.3) into the bore holes of the armature plate (1). (When the brake
has already been installed, cushion the impact energy by pressing against the opposite
side of the armature plate).
2. Screw the eyebolts (12.2) into the mounting plate (16) and align them according to the
hole spacing of the manual release shackle (12).
3. Put clips (12.4) with elongated hole onto the pins (12.3), align thread towards the
eyebolts (12.2).
4. Insert the compression springs (12.5) between clips (12.4) and eyebolts (12.2).
5. Push the trunnions (12.6) into the bore holes of the shackle (12), cross hole to the
outside.
6. Push the Allen screws (10) through the cross holes of the trunnions (12.6).
7. Locate the shackle (12) with trunnions (12.6) and Allen screws (10) such onto the
back of the stator (7) that the Allen screws (10) are led through the eyebolts (12.2)
and the compression springs (12.5).
8. Screw the Allen screws (10) into the clip threads (12.4).
9. When the brake has not been installed yet, tighten the Allen screws (10) until the
armature plate (1) moves towards the stator (7) and remove (throw away) the clips
(11).
10. Adjust gap ”s” and ”s
Lü
” using the Allen screws (10) (values for ”s ” and ”s
Lü
” see
Tab. 6).
11. Secure the adjustment of the Allen screws (10) using the threaded pin (12.7) in the
clip.
Note!
Dimension ”s + s
Lü
” can be checked through the difference of the fitting length
of the compression springs when the armature plate is attracted towards the
stator and the manual release has been adjusted.
12. If necessary, screw the lever into the shackle.
BFK46820-006.iso
