Mechanical installation
4
j
| BA 14.0196 | 05/2013
32
4.5.4
Setting the hand-release
Stop!
For setting the manual release, always lock the pre-assembled hexagon nut of
the tension rod (12.14) against rotation and rotate the self-locking nuts at the
ends of the tension rod only.
Carry out steps 13 and 14 separately for each side of every lever
13. Evenly tighten the self-locking nuts (Pos. 12.8) at the clips (12.11) up to the point
where the nuts of the tension rod are in contact with the armature plate of the second
stator (1A) (tangible resistance). Observe the parallel alignment of the clips (12.11)
with the back side of the complete stator (1A) (check by means of a caliper gauge). In
the case of deviations X > 0.1mm (Fig. 18), correct the setting by loosening the
self-locking nut (12.8) with the smaller measured value and by tightening the
self-locking nut (12.8) with the greater measured value until the clips (12.11) are
aligned in parallel with the back side of the brake, Fig. 18.
14. Evenly tighten the self-locking nuts on the motor end shield side up to the point where
the nuts of the tension rod are in contact with the armature plate of the first stator (1)
(tangible resistance).
15. Loosen the self-locking nuts (12.8) at the clips (12.11) by one revolution (360°).
Carry out steps 16 and 17 separately for each side of every lever
Summary of Contents for BFK455
Page 50: ...Notizen j BA 14 0196 05 2013 50...
