155A
SAVE THESE INSTRUCTIONS
(155IO) POOL LIGHT ENGLISH 7.5” X 9.25” PANTONE 295U 09/18/2017
English
Page 5
SETUP INSTRUCTIONS
This product is specially designed for above ground pool. The LED pool-wall light uses
magnetic technology to create a light system that safety generates low voltage current through
the pool’s sidewall to a powerful LED light inside the pool.
IMPORTANT
• This product is for use with above ground non-steel wall pools with a thickness of 1mm
(0.04 in) or less.
• Do not use this product as a free standing light.
1.
Separate the pool light
(1)
from the transmitter
(2)
by hand through the side opening groove.
See
drawing (1 & 2)
.
CAUTION:
To avoid fi nger pinch or injury, always separate the pool light from the transmitter
through the side opening groove.
2.
Place the transmitter
(2)
on the outside of the pool wall and the pool light
(1)
on the inside of the
pool wall submerged in water. Ensure the transmitter magnetic poles are properly aligned with the
magnetic poles on the pool light unit.
See drawing (3)
.
3.
Adjust the position of the pool light by manually sliding the transmitter position sideways and/or
vertically.
4.
Plug the assembled unit to an electrical outlet protected by a ground-fault circuit interrupter (GFCI)
or residual current device (RCD).
1
2
WARNING
• Always unplug this product from the electrical outlet before removing, cleaning,
servicing or making any adjustment to the product.
• Do not operate the product if transmitter housing or pool light lens is cracked or
showing water leakage; remove from pool or water immediately.
• Never place the power transmitter in water.
3
