(334PO) SOLAR FLOATING LIGHT ENGLISH SIZE: 4.875” X 7.25” 06/19/2017
English
334
PO
SAVE THESE INSTRUCTIONS
Page 3
• The colors cycle emitted by the device under this mode are red, green and blue.
• Any slight movement of the pool water will cause the device to change from “color
changing” to “soft white” light mode. It will stay in this mode for 10 seconds and
then the next water movement will cause it to change back to “color changing”
mode. This cycle repeats with any slight movement of the pool water.
• The device will automatically light up when it gets dark, stays illuminated for
5 hours continuously then switch off to save energy. Press the ON/OFF button
to activate the light again.
• Depending on weather conditions and sun exposure, a full day charge under the
sun provides a total of around 10 hours of illumination.
Troubleshooting Guide
Q.
What should I do if the product does not light up or blinking?
A.
Make sure the device is on, the solar panels are clean and charge the product
under the sun for one full day. The device will not charge if the unit is off.
Q.
What should I do if the light emitted by this product is too weak?
A.
Clean the outside surface using a soft damp cloth. Do not use any hard or
abrasive rag to clean it.
Operation is subject to the following two conditions: (1) this device may not
cause interference, and (2) this device must accept any interference, including
interference that may cause undesired operation of the device. Changes or
modifications not expressly approved by the party responsible for compliance
could void the user’s authority to operate the equipment.
This equipment has been tested and found to comply with the limits for Class
B digital device, pursuant to part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to
try to correct the interference by one or more of the following measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and the receiver.
•
Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
•
Consult the dealer or an experienced radio/TV technician for help.
CAN ICES-005 (B)/NMB-005 (B)
