195
GS
SAVE THESE INSTRUCTIONS
(195GS) SAND FILTER PUMP ENGLISH 7.5” X 10.3” PANTONE 295U 09/18/2017
English
Page 20
1.
Before emptying your pool for long term storage, or relocation, be sure the water is directed towards
an acceptable drain water receptacle away from the house. Check local regulations for specific
directions regarding disposal of swimming pool water.
2.
Switch off the unit, and disconnect power cord from electrical outlet.
3.
When the pool is empty, disconnect all hoses from pump and plunger valves and remove the strainers/
plunger valves from the pool wall.
4.
In a counter clockwise motion unscrew the drain valve cap
(9)
from the drain valve
to thoroughly drain
the tank. The drain valve is located at the bottom of the filter tank.
5.
Disassemble the pump motor from the tank base.
6.
Leave sand filter pump pieces and hoses outside to thoroughly air dry.
7.
Coat the following o-rings and washers with petroleum jelly for long term storage:
•
L-shape
o-ring
(11 & 18)
.
• Pump hose O-rings
(22)
.
• Strainer valve assembly step washers
(23)
.
• Flat strainer rubber washers
(25)
.
8.
Depress the 6-way valve handle and rotate so as to set the pointer on the valve top “N” position. This
allows the water to drain from the valve. Leave the 6-way valve in this inactive position.
9.
It is best to place all dry pieces and pump motor in the original packaging for storage. To avoid
condensation or corrosion problem, do not cover or wrap pump motor with plastic bags.
10.
Store the pump motor and accessories in a dry place. The storage's temperature should be controlled,
between 0 degrees Celsius (32 degrees Fahrenheit) and 40 degrees Celsius (104 degrees Fahrenheit).
11.
Cover the tank with a tarpaulin or plastic sheet to protect it from the weather.
POOL CARE & CHEMICALS
•
All pools require care to keep the water clear and hygienically clean. With proper chemical control, your
filter will help attain this objective. Consult your pool supply dealer for instructions regarding the proper
use of chlorine, algaecide and other chemical agents required for sparkling clear water.
•
Keep pool chemicals away from children.
•
Do not replenish chemicals in pool while pool is occupied. Skin or eye irritations could occur.
•
Daily pH checking and chemical treatment of the water is very important and cannot be
overemphasized. Chlorine, algaecide and maintenance of proper pH levels are required when filling the
pool as well as during the season. Consult your local swimming pool supply store for instructions.
•
The season's first filling of the pool may have brackish water requiring extra water additives and extra
filtering time. Do not allow swimming in pool until the pH level is balanced. Consult your local swimming
pool supply store for instructions.
•
Chlorinated water may damage lawns, gardens or shrubbery as children play in the pool and splash
water outside the pool. Lawn areas underneath the pool liner will be destroyed. Note that some types
of grass may grow through the liner.
•
Filter run time depends on pool size, weather and usage level. Experiment with various run times so
as to produce clean clear water.
•
European standard EN16713-3 lists some additional pool water quality and water treatment information
that can be found at www.intexcorp.com/support.
LONG TERM STORAGE & WINTERIZATION
CAUTION
Concentrated chlorine solutions may damage the pool liner. Always follow the
chemical manufacturer’s directions, and the health and hazard warnings.
CAUTION
Allowing the water to freeze will damage the sand filter and void the warranty.
If anti-freeze solution is needed, use only propylene glycol. Propylene glycol is
non-toxic and will not damage plastic system components; other anti-freezes
are highly toxic and may damage plastic components in the system.
