Intex Krystal Clear SF10220, Owner'S Manual

Page: 19 / 27

(179FR) MODEL SF10220 SAND FILTER PUMP ENGLISH 7.5” X 10.3” PANTONE 295U 08/24/2012
179
FR
SAVE THESE INSTRUCTIONS
Page 19
OPERATING
INSTRUCTIONS
OPERATING INSTRUCTIONS (continued )
English
5. Switch off the pump, change the 6-way valve to “RINSE” position (see
drawing 25) .
6. Switch on the pump and run the pump for about one minute to level out the
sand bed after backwashing the sand media.
7. Switch off the pump, change the 6-way valve to “FILTER” position (see
drawing 23) .
8. Switch on the pump. The system is now operating in the normal filtering mode.
Run the pump until the desired pool water clearance is obtained and no more
than 12 hours per day.
9. Record the initial pressure gauge reading when the filter media is clean.
NOTE: During initial setup of the system, it may be necessary to backwash
frequently due to unusual heavy dirt present in the water and sand. After that,
as the filter removes dirt and impurities from the pool water, the accumulated
dirt in the sand media will cause the pressure to rise and the flow to diminish.
If there is no vacuuming device attached to the system and the pressure gauge
reading is in the yellow zone it is time to backwash the sand media, see
“BACKWASH” under “initial startup and operation” section.
Vacuuming device (i.e. Intex auto pool cleaner) attached to the system may
also cause the flow to diminish and the pressure to rise. Remove any
vacuuming device from the system and check if the pressure gauge reading has
dropped from the yellow zone to the green zone.
Operating the system under “TIMER” mode or manually:
To operate the sand filter pump in “FILTER” mode under “TIMER” control:
A. Set the timer dial to the desired operating hours. See operation time table
(see drawing 31) .
B. Turn on the pump by pressing the switch to “ ” position, the sand filter
pump is now filtering the water and will stop after the operating hours are
completed. The built-in timer will now operate for the number of hours
selected at the same time each day.
C. Operating hours can be re-adjusted if necessary. Follow step A – B.
To operate the sand filter pump manually (without the “TIMER” mode):
A. Turn on the pump by pressing the switch to “-” position, the sand filter
pump is now filtering the water.
B. To turn off the pump, press the switch to “O” position.
31
TIMER
OFF
ON
TIMER DIAL
(HOURS)
IMPORTANT
The filter pump running time should be 1 hour longer than the required
operating time of the Saltwater System.