background image

(106)  MODEL 638R FILTER PUMP  ENGLISH  7.5” X 10.3”  PANTONE 295U  05/13/2014

106A

    

SAVE THESE INSTRUCTIONS

English

Page 10

COMMON POOL PROBLEMS

  PROBLEM             DESCRIPTION                     CAUSE                                SOLUTION

ALGAE

COLORED 
WATER

SUSPENDED
MATTER IN 
WATER

CHRONIC LOW 
WATER LEVEL

SEDIMENT ON 
POOL BOTTOM

SURFACE 
DEBRIS

• Chlorine and pH levels    
 need adjustment.

• Copper, iron or manganese  
  in water being oxidized by  
  the added chlorine.  

 

  This is Common.

• "Hard water" caused  

 

  by a too high pH level.
• Chlorine content is low.
• Foreign matter in  water.

• Rip or hole in pool  

 

  liner or hoses. 
• The drain valves are loose.

• Heavy use, getting in  

 

  and out of pool. 

• Pool too close to trees.   

•  Super chlorinate with shock  

 

  treatment. Correct pH to your
   pool store's recommended level.
•  Vacuum pool bottom.
•  Maintain proper chlorine level.

•  Adjust pH level to the
 recommended 

level.

•  Run filter until water is clear. 
•  Clean cartridge frequently.

•  Correct the pH level. Check  

 

  with your pool dealer for  advice.
•  Adjust the chlorine level.
•  Clean or replace your filter.

•  Repair with a patch kit.
•  Finger tighten all caps.

•  Use Intex pool vacuum to  

 

  clean bottom of pool.

•  Use Intex pool skimmer. 

• Greenish water.
• Green or black   
  spots on pool liner.
• Pool liner is slippery  
  and/or has a bad odor.

• Water turns blue,  
  brown, or black   
  when first treated  
 with chlorine.

• Water is cloudy or  
 milky. 

• Level is lower than  
  on previous day.

• Dirt or sand on   
 pool floor.

• Leaves, insects etc.

GENERAL AQUATIC SAFETY

Water recreation is both fun and therapeutic. However, it involves inherent risks of
injury and death. To reduce your risk of injury, read and follow all product, package and 
package insert warnings and instructions. Remember, however, that product warnings, 
instructions and safety guidelines cover some common risks of water recreation, but do 
not cover all risks and or dangers.

For additional safeguards, also familiarize yourself with the following general guidelines 
as well as guidelines provided by nationally recognized Safety Organizations:

•  Demand constant supervision. A competent adult should be appointed as a “lifeguard” or  
  water watcher, especially when children are in and around the pool.
•  Learn to swim.
•  Take the time to learn CPR and first aid.
•  Instruct anyone who is supervising pool users about potential pool hazards and about the  
  use of protective devices such as locked doors, barriers, etc.
•  Instruct all pool users, including children what to do in case of an emergency.
•  Always use common sense and good judgement when enjoying any water activity.
•  Supervise, supervise, supervise.

Summary of Contents for Krystal Clear 638R












Reviews: